MAINTENANCE & TROUBLESHOOTING
Counter Troubleshooting
MAINTENANCE & TROUBLESHOOTING doc121319 5-6
5
5.4 Counter Troubleshooting
PROBLEM CAUSE SOLUTION
"POWER DEFAULT" message
appears on the display
Power supply interruption Press the START button; the
counter will resume counting the
interrupted sharpening cycle.
Press the RESET button; the
counter will restore the last saved
number of teeth and cycles.
"IMPULSES DEFAULT" message
appears on the display
Malfunction of the induction
sensor or its circuit.
After repairing the induction
sensor, press RESET button.
To Next Page
Loading...
