Safety
Blade Handling
1
1-2 15doc052207 Safety
1.2 Blade Handling
DANGER! Always disengage the blade and shut off the
sawmill engine before changing the blade. Failure to do so
will result in serious injury.
WARNING! Always wear gloves and eye protection when
handling bandsaw blades. Changing blades is safest when
done by one person! Keep all other persons away from
area when coiling, carrying or changing a blade. Failure to
do so may result in serious injury.
1.3 Sawmill Setup
WARNING! Do not set up the mill on ground with more than
a 10 degree incline. If setup on an incline is necessary, put
blocks under one side of the mill or dig out areas for the
legs to keep mill level. Setting up the mill on an incline
could cause it to tip over, resulting in serious personal
injury.
WARNING! Keep all persons out of the path of the saw
head while loading and unloading the sawmill. Failure to do
so may result in serious injury or death.
1.4 Sawmill Operation
DANGER! Make sure all guards and covers are in place
and secured before operating or towing the sawmill. Failure
to do so may result in serious injury.
DANGER! Be sure the blade housing is in place and
secured. Do not open the blade housing, when the blade is
engaged.
DANGER! Always keep hands away from moving bandsaw
blade. Failure to do so may result in serious injury.
DANGER! Keep all persons out of the path of moving
equipment and logs when operating sawmill or loading and
turning logs. Failure to do so may result in serious injury.
DANGER! Maintain a clean and clear path for all necessary
movement around the mill and lumber stacking areas.
Failure to do so may result in serious injury.
WARNING! Always be sure the blade is disengaged and all
To Next Page
Loading...
