Sawmill Alignment
Blade Height Scale Adjustment
6
6-18 15doc052207 Sawmill Alignment
6.11 Blade Height Scale Adjustment
Standard scale
After the entire sawmill has been aligned and all adjustments made, check that the blade
height scale indicates the true distance from the blade to the bed rails.
See Figure 6-16.
1. Move the saw head so the blade is positioned directly above one of the bed rails.
Measure from the bottom edge on a down-set tooth of the blade to the top of the bed rail.
2. Loosen the scale bracket mounting bolt and adjust the bracket until the indicator is
aligned with the correct mark on the scale. Retighten the nut on the bracket mounting
bolt.
FIG. 6-16
Loosen the bolt
To Next Page
Loading...
