Wood-mizer LT10 - Motor Drive Belt Adjustment

Sawmill Alignment
Motor Drive Belt Adjustment
6
6-20 15doc052207 Sawmill Alignment
6.12 Motor Drive Belt Adjustment
See Figure 6-18. Loosen the motor mounting bolts. Using the adjustment bolts shown
below, adjust the drive belt until it has 7/16" (11 mm) deflection with a 8 lbs (3.6 kG)
deflection force - in the case of E11 motor or 7/16" (11 mm) deflection with a 16 lbs (7.2
kG) deflection force - in the case of E15 motor. Tighten the four motor mounting bolts.
FIG. 6-18
Motor Mounting
Bolts (4)
Adjustment
Bolts