Wood-mizer LT70 Series Operator's Manual

Operation
Operation
1
1-6 doc021820 Operation
SW-10 Operator’s Manual);
 Position the saw head at a height of the first cut;
 If necessary, turn the debarker on;
 Set the Blade Drive On/Off Switch in the upper position;
 Push the left joystick forward and hold it in this position. The blade drive will be turned on within
3 seconds.
 Set the feed rate dial to the desired value.
 After making the cut, release the left joystick. The blade drive will be turned off and the main
engine will still be running idle.
 After position the saw head for the next cut, push the left joystick forward and hold it in this
position. The blade drive will be turned on within 3 seconds.
NOTE: As soon as the joystick is released, the blade drive is
disengaged.
NOTE: If none of the pushbuttons, switches or joysticks is used within
5 minutes after switching on the transmitter, the transmitter will turn off
automatically.
When sawing is finished, switch the transmitter off by turning the starting key to the ”0” position.
Remove the key and always store it in a safe place.
NOTE: The starting key (Air-KEY) stores the receiver identification
data. The transmitter cannot communicate with the receiver without
this key. Do not lose the Air-KEY.

Wood-mizer LT70 Series Specifications

General

Hydraulic Log Handling	Optional
Computer Setworks	Optional
Blade Width	1.5 inches (3.8 cm)
Power Options	Electric or diesel
Head Controls	Manual
Cutting Method	Horizontal bandsaw