OPERATING & INSTALLATION
INSTRUCTIONS
DT10RF OPTIMISING PROGRAMMER
INSTRUCTION MANUAL
8 716 115 494a (02.2009)
14
NOTE: Option 5 must be completed or at least “stepped
through” using the > key before option 6 can be
accessed
Option 06 How to change temperature offset.
The temperature displayed on the thermostat may not match that
of other temperature measuring devices in the controlled space,
because of its location.
The displayed temperature may be offset to bring it in line with
other devices.
1. To adjust the temperature, enter the user options by pressing
< and > simultaneously for 3 seconds.
2. Select option 06 by pressing > until 06 appears.
3. The temperature may be offset by +/- 5 degrees by pressing
the + and – keys.
Press > to accept the desired change.
Option 07 How to restore the built in time temperature
programs.
NOTE: Switching this option on will delete any user changes to
the preset programs.
1. Enter the user options by pressing < and > simultaneously for
3 seconds.
2. Select option 07 by pressing > until 07 appears.
3. Use + and – keys to select desired option.
Off = current programs retained.
On = restore factory program settings.
Press > to select the desired change.
The option 07 display automatically reverts back to off.
Option 08 How to disable the OFF function.
1. To dis able the Off function, enter user options by pressing
< and > simultaneously for 3 seconds.
2. Select option 08 by pressing > until 08 appears.
3. Use + or – keys to select Off.
Press > to accept change.
It is now not possible to switch the Digistat Off using the + and-
keys as previously described.
To en ab le th e O ff fu nc ti on r e tur n t o o p tio n 0 8 an d s el ec t O n .
Press > to accept change.
To Next Page
Loading...
Need help?
General
