Getting started
EN
15
1.2 Plan for the RFID used for multi-zone
If you have separated lawns, the equipped RFIDs can help Landroid Vision navigate the passage or pathway and cut the
separated lawn areas. The Landroid Vision follows the lawn edge and senses all the RFID cards to explore the zones in the first
travel. The mower will follow its working schedule, sense the RFID card and come across to another zone to complete its work
afterwards.
Each Landroid Vision will be equipped with 2 RFIDs. You need to install the RFID in each zone. If you have two separated lawns,
you can refer to Figure 5 to install the RFID. If you have three separated lawns, you can refer to Figure 6 and Figure 7 to install
the RFID.
To make sure the RFID work well, please help check:
• there are no obstacles or large area of bare grass and the edge is straight within 1.5 m around the RFIDs.
• there is a clear boundary besides the RFID.
• the ground under RFID is flat.
• no wires and strong magnet devices within 30 cm around the RFID to avoid signal interference.
• make sure the path between each zone is shorter than 6 m and that the height of any steps on the pathway are less than 3
cm.
NOTE: If the RFID’s supplied are not enough for you, you can purchase more from our retail partners and online.
1. PATROL YOUR LAWN TO PLAN INSTALLATION
1.1 Plan for the charging base (See Fig. 1 - Fig. 4)
The charging base composed of charging base plate and charging tower, is where your Landroid Vision goes to have its battery
recharged. It’s also the parking lot where it rests in between one mowing session and the next.
Locate a proper position for it, bearing in mind:
• The station needs to sit on flat land to ensure effective docking.
• It needs 2 m straight driving path in front for Landroid Vision following the edge and entering the charging base.
• There isn’t a large area of bare ground or sparse grass within the 2 m driving path to enter the charging base.
• The QR code on the charging tower is clear.
• It needs to be powered and be no more than 10 m away from an AC mains outlet.
• If possible, choose a shaded position as batteries and chargers don’t like over-heating.
• Avoid places close to irrigation sprinklers.
• Make sure Landroid Vision enter right towards to the charging base and depart in anti-clockwise direction.
0°
0°
1
3
2
Wed.11/29 09:00PM
Wed.11/29 09:00PM
General setting
Set date&time
Rain start delay
APP Link
Define zones
1
2
1
2
4
To Next Page
Loading...
