Worx WR213E - Remove the Charging Tower

Maintenance
EN
32
Over-the-Air (OTA) updates
If your Landroid Vision is connected to your Wi-Fi network, you will be notified that new software is available via the App. Once
you confirm, the update will happen automatically Over-the-Air.
Manual updates
• If your Landroid Vision is not connected to your Wi-Fi network, you can still update it to the latest software version with a USB
stick.
• Regularly visit the Worx Landroid Vision website to check if any new version is available. If you subscribed to Landroid Vision
email list, you will be notified when a new version is available.
• Download the latest software version at our website.
• Take a blank USB stick formatted in FAT32.
• Save the file and extract the content to your USB stick.
• Make sure your Landroid Vision is getting charged.
• Turn off Landroid Vision.
• Open the battery cover of the Landroid Vision to access the USB port.
• Insert the USB stick in the port.
• Turn on Landroid Vision.
• Without lifting Landroid Vision, remove the USB stick when “Please remove the USB key” is displayed.
• The update will begin automatically and may take a while. Landroid Vision will restart automatically after the update is comple-
ted.
NOTE: Make sure Landroid Vision is charging or the battery capacity has reached 50% prior to starting the firmware update.
Remove the charging tower
• Simultaneously press the two clips on the charging tower cover to remove the charging tower cover.
• Use a screwdriver against the charging tower pin, then remove the charging tower.
NOTE: When Landroid Vision is not in use for a long time, removing and properly storing the charging tower can prolong the
service life of the charging base.
1
2