Quick reference
EN
36
TROUBLE SHOOTING
If your Landroid Vision does not work correctly, follow the trouble shooting guide below. If the fault persists, contact Customer
Service.
SYMPTOM CAUSE SOLUTION
The LED light on the charging
pile does not turn on.
There is no power.
Check the charging base is connected properly to the
charger and the charger is connected to a suitable power
supply.
Landroid Vision turns on,
but the blade disc does
not spin.
Landroid Vision is searching for the
charging base.
This is normal: when Landroid Vision needs to recharge,
the blade disc does not rotate while it is searching for the
charging base automatically.
Landroid Vision vibrates.
The blade disc is unbalanced.
Blades may be damaged.
Check the blades and replace them if damaged.
Remove debris and foreign objects from the blades and
blade disc.
Grass is being cut
unevenly.
Landroid Vision does not work enou-
gh hours per day to cut the grass.
Try adding more hours to the mowing schedule.
Mowing area is too big for the size of
Landroid Vision you have.
Try decreasing the size of the mowing area or increasing
working time.
The blades are dull and not sharp.
Change all the blades and screws in order to balance the
bade disc.
The cutting height is set too low for
the length of the grass.
Raise the cutting height and then gradually lower.
Grass or another object has wrapped
around the blade disc.
Check the blade disc and remove any grass or other
objects that might prevent it spinning.
There is a build-up of grass in the
blade disc or motor frame box.
Make sure the blade disc rotates easily. If need be, you
may take off the blade disc and then remove the debris.
Recognition error
Remove the obstacles, such as piles of leaves, weeds
and wildflowers.
The secondary area is
not mowed.
Programming error
Make sure the RFIDs are installed correcly and repro-
grammed.
There are obsacles between the
RFIDs in the pathway.
Remove the obstacles.
The boundary of the passage within
1.5 m range of the boundary wire for
the RFID is curved.
Ensure that there is no boundary curved within 1.5 m
range of the boundary wire for the RFID.
The charging time is
far more than the rated
charging time.
Poor connection caused by debris on
the charging strip.
Clean the contact pins located on the charging pile and
the charging strip on Landroid Vision using a cloth.
The charging protection program is
activated due to high temperature.
Place the charging base in a shady area or wait until the
temperature has cooled down.
The mower does not
charge.
There is no power.
Check the power cord is connected properly to the
charger and the charger is connected to a suitable power
supply.
Make sure both the charging strips on the mower touch
the center of the charging contacts on the charging pile.
To Next Page
Loading...
Need help?
General
