Quick reference
EN
35
MESSAGE CAUSE ACTION
Battery voltage too
low! Please change
battery.
Battery exausted, and needs
to be recharged.
In this case you must turn Landroid Vision off and place it in the
charging base, then ‘Emergency charging’ will be displayed and it will
start charging. If the battery error still persist, your battery is damaged
and need to be changed.
Battery temperature
out of range!
Please wait.
Temperature is too high (more
than 45
0
C) or too low (less
than 4
0
C) when charging.
Place the charging base in a shady area or wait until it reaches the
normal temperature.
Can’t find charge
station! Press START
to reset.
Machine doesn’t have
enough power to go back to
charging base.
Take Landroid Vision to the charging base.
Mower locked!
With the “Lock Function”
enabled, if your Landroid
Vision does not receive a
signal from your Wi-Fi router
for 3 days, then it gets locked
as a security measure.
This could be because
your router lost its power
or because you changed
your Wi-Fi router or network
provider.
Please reconnect Landroid Vision to the Wi-Fi networtk it has been
originally paired with. If this is not possible, contact Cutomer Service.
RFID not found!
RFID is not installed correctly. Check if RFID is correctly installed.
RFID signal is weak. Install the RFID with same number beside the original one.
Camera blocked!
Camera covered by dirty
things.
Clean the camera.
NOTES
• Before turning power on, always check Landroid Vision is inside its working area. If not, the message “Outside working area!
Press START to reset” will be displayed. This message is also displayed when Landroid Vision is partly but not completely
inside its working area.
• If for any reason—i.e. a party, children playing...—you want to park your Landroid Vision in the charging base: press then
. Landroid Vision will go to its base and stay there. Please note Landroid Vision will now wait until the next scheduled
mowing session. If you want to re-start it at anytime, press then to start your Landroid Vision.
• If an error repeatedly occurs in the same area of your lawn, you might have a problem with the working area so please refer
to the installation instructions and check your set up is correct with its help.
• If your lawn is divided in two separated areas, connected by a corridor less than 1m wide, one of which is not provided with
the charging base: when Landroid Vision runs out of charge, take it manually to the charging base.
• If Landroid Vision runs abnormally once in a while, please reset it by turning it off and removing the battery for 30 seconds,
then restart it. If the problem cannot be solved, please contact our Customer Service for help.
To Next Page
Loading...
