Worx WX529 - General Power Tool Safety Warnings; Work Area Safety; Electrical Safety; Personal Safety

Lithium-Ion cordless circular saw EN
6
1. LOCK-OFF BUTTON
2. ON/OFF SWITCH
3. FRONT HANDLE
4. SPINDLE LOCK BUTTON
5. BASE PLATE ANGLE SCALE
6. BASE PLATE BEVEL LOCK KNOB
7. CUTTING MARK, 45°
8. CUTTING MARK, 0°
9. BASE PLATE
10. LOWER GUARD LEVER
11. LOWER BLADE GUARD
12. FIXED GUARD
13. DUST ADAPTER
14. BATTERY PACK *
15. BATTERY PACK RELEASE BUTTON
16. SPINDLE (See Fig. B)
17. INNER FLANGE (See Fig. B)
18. SAW BLADE (See Fig. B)
19. OUTER FLANGE (See Fig. B)
20. BLADE BOLT (See Fig. B)
21. CUTTING DEPTH SCALE (See Fig. C)
22. HEX KEY (See Fig. C)
23. CUTTING DEPTH LOCK KNOB (See Fig. C)
24. HEX KEY STORAGE AREA (See Fig. C)
25. ADJUSTMENT SCREW (See Fig. C)
26. DUST EXTRACTION OUTLET (See Fig. H)
*Not all the accessories illustrated or
described are included in standard delivery.
TECHNICAL DATA
Type WX529 WX529.9 (5-designation of
machinery, representative of Saw)
WX529 WX529.9
Rated voltage 20V
Max**
No load (rated) speed 3600 /min
Blade size 150mm
Blade bore 16mm
Saw blade thickness
TCT blade
1.8mm
Max cutting depth 45mm
Cutting
capacity
Cutting
Depth at
45°
33mm
Cutting
Depth at
90°
45mm
Bevel capacity 0-50°
Machine weight 2.75kg 2.37kg
**Voltage measured without workload. Initial battery
voltage reaches maximum of 20 volts. Nominal
voltage is 18 volts.
NOISE INFORMATION
A weighted sound pressure L
pA
: 83.2dB(A)
A weighted sound power L
wA
: 94.2dB(A)
K
pA
&K
wA
3.0dB(A)
Wear ear protection
VIBRATION INFORMATION
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Vibration
emission value:
Cutting wood: a
h, W
= 6,163m/s
2
Uncertainty K = 1,5m/s²
The declared vibration total value may be used for
comparing one tool with another, and may also be
used in a preliminary assessment of exposure.
WARNING: The vibration emission value
during actual use of the power tool can differ
from the declared value depending on the ways in
which the tool is used dependant on the following
examples and other variations on how the tool is
used:
How the tool is used and the materials being cut .
The tool being in good condition and well
maintained
The use the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration accessories are used.
And the tool is being used as intended by its design
and these instructions.