ENCordless Circular Saw
16
TROUBLE SHOOTING
Symptom Possible Causes Possible Solution
Tool will not start when operating
the on/off trigger.
Battery park not plugged in.
Battery park is powered off.
Carbon brush has worn down.
Check to make sure battery park is
connected well into a working outlet.
Charging the battery.
Replace the carbon brush using a
qualified maintenance person.
Cutting depth is less than that
is set.
Sawdust accumulated at the
rear of the base.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Blade spins or slips
Blade is not tightly engaged
with the spindle.
Remove the blade and reassemble it as
described in Mounting and Removing
the Blade section.
Blade will not cut a straight line.
Blade is dull.
Blade is not mounted properly.
Saw is not being guided
properly.
Mount a new, sharp blade on the saw.
Check that blade is properly mounted.
Use a parallel guide.
Blade kicks back when beginning
a cut
Saw blade teeth may be
engaged in the material when
starting.
Blade is not spinning fast
enough.
Before restarting a saw in the
workpiece, center the saw blade in the
kerf and check that the saw teeth are
not engaged into the material.
Allow the saw blade to reach full speed
prior to beginning a cut in the material.
To Next Page
Loading...
