WPI EVOM3 - USB Testing

EVOM3
World Precision Instruments 17
USB Testing
From the Store Options page you can test a USB thumb drive to verify that it can be
used. This drive must be formatted as FAT32.
1. Insert the drive to see if it is recognized by the EVOM3.
2. From the main page, press the
Settings button. Press the Store button. Then,
press the USB Test button.
Fig. 26—Press the Test USB button to run the test.
3. Press the
Test USB button to run the test or Return to abort the test. The USB
die ill e itten t ith  line  data t a file named tt and
those lines will be read back. If the drive is usable a message indicates that the
USB thumb drive can be used, otherwise an error is displayed.
Fig. 27—(Left) The USB thumb drive passed the test and is suitable for use with the EVOM3.
Fig. 28—(Right) The USB thumb drive is not suitable for use with the EVOM3.
4. Insert another USB thumb drive and press the
Test USB button to test another
drive or press Return to go back to the Store Options page.