WPI EVOM3 - Quick Start; Resistance; Voltage

EVOM3
World Precision Instruments 1
QUICK START
Resistance
1. Power on the EVOM3 using the power switch on the rear panel.
  a filename the than the dealt (late) i eied
• Press and hold the Store button for 2 seconds to enter the Store Option menu.
• Select Filename to enter a new name.
• Press Clear .
• Use the on screen keypad to enter a new name.
• Press Enter .
NOTE t indeing hange the name t a nmei eene matted ith
the name, a efi and a eential nme (nameefi)
3. Press
Setup to access the Setup menu.
• Select Mode–Set the mode to Resistance.
• Select Plate–Choose the plate size.
• Display Units– Select the display units in ohms or K-ohms.
• Resistance–Select the resistance range (auto or the desired range).
• aliatee aliate t aliate the eletde (hi e a K Ω
resistor to calibrate the cell ranges).
4. Press
Return to navigate back to the main menu.
5. Insert a USB thumb drive into the USB port on the side of the EVOM3 and begin
measuring by pressing the foot switch or touching the
Store button on the screen
to store and advance to the next weel. Tap the Next Well area on the right side of
the screen to advance in increments of one well without taking a measurement.
Repeat the sampling process.
 ne the lat ell ha een eded, the file ting eletin ntifiatin
appears. Press
Store . A system message will report if the USB thumb drive is
usable, or it will display an error. If the USB thumb drive is not plugged in or it
is not recognized, a warning message will appear. Press Cancel and try another
drive. The Store function cannot be used on an unrecognized drive. EVOM3
hld end ith File aed ithin  end  aing file i till een
after 20 seconds, press the Return e and e anthe  die ne a file ha
een aed, en the file n a mte t ei the ntent
NOTE he file aing tine an tae  t  end t mlete ee the
USB cautions on page 5.
 Reme the  thm die and tane the data file t  mte a a
V file (el)
Voltage
1. Power on the EVOM3 using the power switch on the rear panel.
  a filename the than the dealt (late) i eied
• Press and hold the Store button for 2 seconds to enter the Store Option menu.