Wren V5US - Using the V5 US Bass EQ

English
7
Your V5US is equipped with a 3-position bass equalization (“EQ”) switch to compensate
for room “boundary eects” on bass output. Room boundaries can change the sound of
a speaker because its bass output is either amplified or diminished depending on how
near the speaker is to the room’s walls, floor or ceiling. A speaker placed a good distance
away from a room’s walls, floor or ceiling will be free from the amplifying eects of these
boundaries. At the opposite end of the spectrum, a speaker placed in a corner on the
floor or up near the ceiling will most likely have overwhelming and unnatural sounding
bass output, assuming that its inherent bass output is powerful enough to begin with, as
is the case with your V5US.
We provide the Bass Adjustment EQ Selector, pictured below, to allow greater flexibility
in room placement of your V5US. If your speaker is a good distance from any room
boundaries, use the left-most setting. If your speaker is near a back wall, use the middle
setting. Finally, if your speaker is in a corner, use the right-most setting.
Of course, bass output is for many people a matter of personal taste. If the bass on your
V5US seems too light for your taste — regardless of room position — you can make it
heavier by moving the setting to the left. If the bass is too heavy — regardless of room
position — you can make it lighter by moving the setting to the right.
Free from
boundaries
In a corner
Near a wall
RESET
EQ
Using the V5US Bass EQ