Wren V5US - Connect to your network using WPS (if your router supports it); WiFi Protected Setup (WPS) Explained

28
Press and hold the setup button on
the rear of the product for three
seconds, then release. The WiFi
indicator will blink amber two times,
then pause every second. The speaker
is now in WPS Mode.
Plug in the Wren V5US speaker near
your router. Wait approximately
10 seconds for the speaker to fully
power on (when the power indicator
light stops blinking).
WiFi Protected Setup (WPS) is a feature on some WiFi routers that allows the Wren V5US
speaker to automatically and securely connect without needing to enter a password. WPS is
not a standard feature on all routers, and only one Wren V5US speaker can be set up at a time.
Check your router’s owner manual to see if WPS is a feature, or look for a button on your
router marked with the WPS logo
. If your router does not have WPS, then use the
method appropriate to your device. (See the Index on page 9 to locate Setup instructions
for your device.)
If your router has WPS, use the following instructions.
WiFi Protected Setup (WPS)
Connect to your network using WPS (if your router supports it)
solid white
blinking
amber