English
11
Troubleshooting tips
WiFi light is not blinking
amber slowly (once per
second) during setup.
Solution
WiFi indicator is solid white.
The speaker is already connected to your WiFi network. Go to
the speaker settings in the app and select your Wren Speaker.
WiFi indicator is blinking
faster than once per second.
Put the speaker into setup mode by holding the setup button
on the back panel for about 7 seconds. Release when the
amber light blinks slowly (once per second).
WiFi light is double-blinking
two times every second.
The speaker is in WPS setup mode; if you are not using WPS
for setup, press and release the source button once. (For more
on WPS, see the Setup Guide.)
Setup Fails Solution
If setup fails multiple times,
the speaker may be too far
from your router.
Move your speaker closer to the router.
If you need any help with set-up, consult the Setup Guide included with your speaker or visit
our website at http://wrensound.com/support/V5us to view troubleshooting or to contact our
customer support.
To Next Page
Loading...
