Wyrestorm SW-640L-TX-W - Network Mode Configuration; Using SELECT Button to Perform EDID Copy

11
Example 2: Multiview Display Mode
Network Mode Configuration
The device equips three Ethernet ports for networking flexibility and security, which supports the following two network modes:
Transparent Mode (Default Setting)
In this mode, all three Ethernet ports are inter-connective with others, any one of which is able to connect to the LAN where a controller resides for
controlling the device, and the rest can be used for BYOD.
Isolated Mode
When the conguration item “Secure Ethernet Mode” on web UI are set to Enable, Isolated mode is activated. For more information about enabling
“Secure Ethernet Mode”, refer to Secure Ethernet Mode section. In Isolated mode, the CONTROL port is used for controlling the device; the other two are
for BYOD communication and for the attached device to access network.
Using SELECT Button to Perform EDID Copy
The SELECT button can be used to copy EDID of the corresponding HDMI display to the selected input port.
1. Before you perform EDID copy, complete the following:
a) Select only one input port for the certain HDMI output at one time, ensure the input port is connected to a valid video source.
b) Connect the HDMI output to an HDMI display.
2. Press and hold the SELECT button for at least 2 seconds, if the input port LED blinks 3 times quickly, it indicates that the EDID copy succeeds; if all
input port LEDs of the HDMI output blink 2 times quickly, it indicates that EDID copy fails.