Wyrestorm SW-640L-TX-W - Wiring; Application 1: Single HDMI Output; Application 2: Dual HDMI Output

To Next Page

To Previous Page

Attaching Installation Brackets

1. Attach the installation bracket to the enclosure using the screws provided in the package. The bracket is attached to the enclosure as shown.

2. Repeat step 1 for the other side of the device.

3. Install the brackets on the position as required using screws (screws are not included in the package).

Wiring

Warning! Before wiring, disconnect the power from all devices. During wiring, connect and disconnect the cables gently.

Application 1: Single HDMI Output

Features

• In this application scenario, only one HDMI display is connected

to either HDMI OUT 1 or HDMI OUT 2, and up to four video sources

can be displayed on the single screen (quadruple view).

• Your laptop is connected to the device’s USB-C IN port, this setup

brings you the best experience. An alternative connection is the

combination of the USB HOST and HDMI IN port.

• You can use a Dongle to connect your laptop to the device plus

the camera and speakerphone wirelessly at the device after the

Dongle is paired with the device successfully.

• You can project the screen content of your laptop and mobile

devices to the device wirelessly over Airplay Mirroring and Miracast.

• This device is congured in Isolated Network mode: the

CONTROL port is assigned specically to the controller for

controlling this device, the ETHERNET 1/2 port can be used for

BYOD communication and the attached PC to access network.

Application 2: Dual HDMI Output

Features

• In this application scenario, two HDMI displays are connected to

two HDMI outputs respectively, which can be bound to the laptop

attached to USB-C IN 1/2 as two extended desktops.