19
Access Point
UI Element Description
Soft AP
Click to enable/disable the device’s soft AP function.
Default setting: Enable
Soft AP Password
Congure the soft AP password.
Default setting: 12345678
Soft AP Router
• Enable: Enable the device’s soft AP router function so that wireless devices connected to soft AP are able to access
the internet (verify the Ethernet port of the device is connected to the internet).
Note: When the device’s IP mode is set as Static, you must congure the Ethernet port’s gateway and DNS correctly so
that soft AP router runs properly.
• Disable: Disable the device’s soft AP function to prevent wireless devices connected to soft AP from accessing
the internet.
Default setting: Enable
Note: Before you intend to use this feature, ensure the soft AP function is enabled.
BYOD Feature
Click to enable/disable the device’s BYOD feature.
Note: This feature is available for Airplay and Miracast, not for Dongle.
Access Code
Enter a four-digit access code to help prevent users from accidentally connecting to an unintended device and
protect from an unauthorized access.
• When an access code is set, it will appear on the upper right corner of the attached display.
• If you don’t want to set access code, you can enter nothing here.
By default, it’s set as blank.
Apply Click to perform current settings.
To Next Page
Loading...
