15
This section is for security settings to limit unauthorized access to the device.
Web Password
Firmware
UI Element Description
Telnet over TLS
To enable/disable TLS authentication for telnet connection.
Default setting: Disable
Old Password Input the old password for the telnet over TLS authentication.
New Password Congure a new password for the telnet over TLS authentication.
Conrm Password Conrm the new password again for the telnet over TLS authentication.
HTTPS
Click to enable/disable HTTPS authentication service.
Default setting: Enable
Show IP address on Guide
Screen
Click to enable/disable IP address display on Guide Screen.
Default setting: Enable
Apply Click to save and perform current settings.
UI Element Description
Browse Click to browse for the local upgrade le.
Apply Click to upload the rmware le to the device and perform rmware upgrade.
Reboot Click to restart the device.
Reset to Factory Default
Click to restore the device to its factory defaults.
You can also perform this task by using the Reset button on front panel.
Expert Log Click to export system log.
UI Element Description
New Password
Set a new password to log on to the device’s web UI page.
Note: The new password must be 4 to 16 characters in length, alphanumeric only.
Apply Click to perform current settings.
To Next Page
Loading...
