5
Control
Control Connector
• Front panel buttons
• 1x LAN (one of the three LAN ports)
• RS-232
Control Method Front panel buttons, LAN (Web UI & Telnet API), RS-232
General
Operation Temperature 0 to 45°C (32 to 113°F), 10% to 90%, non-condensing
Storage Temperature -20 to 70°C (-4 to 158°F), 10% to 90%, non-condensing
ESD Protection Human-body Model: ±8kV (Air-gap discharge)
Power Supply 20V 10A DC
Power Consumption 160W (Max)
Device Dimensions (WxHxD) 215mm x 42mm x 180.2mm / 8.46” x 1.65” x 7.09” (Antennas not included)
Net Weight 1.18kg/2.60lbs (Antennas not included) / 1.20kg/2.64lbs (Antennas included)
# Name Description
1 Power LED
On: The device is powered on.
Off: The device is powered off.
2 Status LED
On: The device is working properly.
Off: The device is in standby status.
3
HDMI Output 1
USB-C 1 ~ HDMI 2 LEDs, each of which includes three indications:
On: The corresponding video source is valid and being output to HDMI OUT 1.
Blinking: The corresponding video source is being output to HDMI OUT 1 but not valid.
Off: The corresponding video source is not being output to HDMI OUT 1.
4
SELECT Button that provides two operation methods:
• Short press to cycle through the four input sources USB-C 1, USB-C 2, HDMI 1 and HDMI 2.
• Press and hold for at least two seconds to copy EDID of the HDMI display at HDMI OUT 1 to the selected
video source. For more information, refer to the Using SELECT Button to Perform EDID Copy section.
5
HDMI Output 2
USB-C 1 ~ HDMI 2 LEDs, each of which includes three indications:
On: The corresponding video source is valid and being output to HDMI OUT 2.
Blinking: The corresponding video source is being output to HDMI OUT 2 but not valid.
Off: The corresponding video source is not being output to
6
SELECT Button, provides two operation methods:
• Short press to cycle through the four input sources: USB-C 1, USB-C 2, HDMI 1 and HDMI 2.
• Press and hold for at least two seconds to copy EDID of the HDMI display at HDMI OUT 1 to the selected
video source. For more information, refer to the Using SELECT Button to Perform EDID Copy section.
7 Dongle Pairing USB-C connector. Connect to a Dongle for pairing or for upgrading the dongle’s rmware.
8 Reset
A recessed button that provides two operation methods:
• Short press the button to show OSD (On-screen Display) on the attached HDMI displays.
• Press and hold the button for at least ve seconds and then release, the device will automatically reboot
and restore to its factory defaults.
Panel Description
Front Panel
87654321
To Next Page
Loading...
