14
This section is for network settings of the device’s Ethernet ports.
For Primary Ethernet port:
For Secure Ethernet Mode:
For Secondary Ethernet port:
When “Secure Ethernet Mode” is set to Enable, the IP settings are similar with that of the Primary Ethernet Port, but you must ensure that the Primary and
Secondary Ethernet ports are set to different network segments.
Network Security
UI Element Description
IP Mode Select IP addressing mode between DHCP and Static. Default setting: DHCP
IP Address Set IP address manually for the device when Static mode is selected.
Netmask Set subnet mask manually for the switcher when Static mode is selected.
Gateway Set gateway address manually for the device to communicate with another network when Static mode is selected.
DNS Server 1
Set DNS server manually for the device to ensure normal network communication.
DNS Server 2
Apply
Click to save and perform current settings.
Note: After the IP settings are changed, please refresh the Web UI page to log back in.
UI Element Description
Secure Ethernet Mode
To enable or disable the Secure Ethernet Mode.
• Enable: Select to activate Isolated mode.
In Isolated mode, setting of “Secondary Ethernet Port” is available, and “Primary Ethernet Port” is associated with the
CONTROL port for controlling this device, “Secondary Ethernet Port” is associated with the network where Ethernet 1/2
is connected for BYOD communication and network access.
• Disable: Select to activate Transparent mode.
In Transparent mode, setting of “Secondary Ethernet Port” is unavailable, all three Ethernet ports are interconnective
with others.
Default setting: Disable
Note: For more information about the two network modes above, refer to Network Mode Conguration section.
To Next Page
Loading...
