PPG DIGIMATCH SPECTROPHOTOMETER
2
USA – FCC Supplier Declaration of Conformity Product Identification and Responsible
Party
X-Rite [2.1077(a)(3)]
www.xrite.com
4300 44th St SE
Grand Rapids, MI 49512
MAC-Spectrophotometer [2.1077(a)(1)]
We, X-Rite, declare under our sole responsibility that the product MAC-Spectrophotometer complies with
Part 15 Subpart B of FCC CFR47 Rules.
FCC Compliance Statement FCC 15.19 Labeling Requirements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void
the user’s authority to operate this equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-able protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
installation. If this equipment does cause harmful interference to radio or television reception, which can
be deter-mined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC RF Exposure Statement
The device shall be used in such a manner that the potential for human contact normal operation is
minimized. This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20cm between
the radiator and your body. This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
Canada ISED Compliance Statement
CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada’s license-exempt RSSs. Operation is subject to the following
two conditions:
To Next Page
Loading...
Need help?
General
