PPG DIGIMATCH SPECTROPHOTOMETER
24
8. Tap the icon to toggle between delta L*a*b* and L*a*b* data.
Inspect
The Inspection mode is used to take a photo image of a measurement zone that can be saved as an image.
1. Tap Inspection on the Apps screen to open the Inspection screen. The device automatically goes into
targeting mode.
Health Check
The Health Check is typically performed with the standard calibration that is due after 30 days. However, a
Health Check can be initiated in case you experience issues during the operation of the device.
Viewing Details
1. Tap Health Check on the Apps screen to open the Health Check screen.
2. Tap Detail to view the current device details.
3. Tap Send if you want to transfer the device status.
NOTE: Please perform the health check after every calibration cycle.
Performing a Health Check
1. Tap Health Check on the Apps screen to open the Health Check screen.
2. Tap the Start button.
To Next Page
Loading...
