PPG DIGIMATCH SPECTROPHOTOMETER
21
8. You can edit the name for the job if desired. Tap the icon and enter a job name using the virtual
keyboard. Tap the icon to save the job name.
Delete Job
Tap the icon on the screen and then tap Yes to confirm that you want to delete the job you measured.
Job List
The Job List mode is used to measure downloaded jobs and delete saved jobs. The device stores
measurements as jobs (multiple measurements per job).
1. Tap Job List on the main screen.
2. Select a job that was sent via the PPG PAINTMANAGER ® XI software. Jobs that have not been
measured are shown “unchecked” next to the name.
3. Follow the measurement procedure as described in the section New Job above.
To Next Page
Loading...
Need help?
General
