What to do if X-Rite Measuring Instruments calibration procedure fails?
If the calibration procedure fails on your X-Rite Measuring Instruments, the calibration reference may be dirty or damaged. Clean the reference, following the appropriate procedure. If it is damaged, replace it.
Why are my X-Rite Measuring Instruments measurements inaccurate?
Inaccurate measurements from your X-Rite Measuring Instruments may occur if a measurement or calibration has failed. If this happens, clean the instrument optics and calibration reference. Then, turn the instrument off and on again.
What to do if X-Rite Measuring Instruments and software are not communicating?
If your X-Rite Measuring Instruments and software aren't communicating, ensure the interface cable is correctly connected between the computer and the instrument. Then, close and restart the software application. If the problem persists, reboot the computer. Remove and reapply power to the instrument. Also, check for the correct configuration settings from the software provider.
How to fix X-Rite Measuring Instruments repeated sample measurement failures?
To resolve repeated sample measurement failures with your X-Rite Measuring Instruments, first, ensure that the sample is being read according to your software’s documentation. Then, close and restart the software application. Finally, perform a calibration on the instrument.
What to do if my X-Rite Measuring Instruments is not responding?
If your X-Rite Measuring Instruments is not responding, it could be due to a very low or bad battery pack. Try charging the battery. If the battery pack is faulty, replace it. Alternatively, ensure that the battery pack is installed or that the AC adapter is plugged in.
What to do if X-Rite Measuring Instruments navigation control buttons are non-responsive?
If the navigation control buttons on your X-Rite Measuring Instruments are non-responsive, turn the instrument off and then back on to reset their operation.
Details the items included in the instrument packaging, such as the device, accessories, and documentation.
Overview of the device's buttons, navigation control, and LED indicators for operation.
Configures how measurements are initiated, such as using the button, shoe, or software.
Step-by-step guide for performing essential white and black calibration for accurate measurements.
How to choose the operational mode, e.g., QA, Compare, Strength, or Opacity.
Choosing the colorimetric system (e.g., Lab, XYZ) to display measurement results.
Procedure for organizing standards by creating custom projects.
Guide to selecting a specific standard from a list for comparison.
Instructions for selecting and executing measurement sequences (jobs) downloaded from software.
General| Wavelength Interval | 10 nm |
|---|---|
| Spectral Range | 400 nm - 700 nm |
| Repeatability | ΔE*ab 0.02 (white tile) |
| Battery | Rechargeable Li-ion battery |
| Connectivity | USB, Bluetooth |
| Measurement Area | 6mm, 4mm, 10mm apertures |
| Operating Conditions | 10-40°C, 20-85% RH (non-condensing) |
| Storage Conditions | -20°C to 50°C, 10-90% RH (non-condensing) |
| Power Source | AC adapter or rechargeable battery |
To Next Page
