CI6X SERIES SPECTROPHOTOMETER
38
Manually Selecting Standard by Name
To select standard by name:
1. Select the project where the standard is located.
2. From the Measure screen, use the Up or Down navigation buttons to move the highlight focus
to the Standard icon
.
3. Tap the Select or Right navigation button to access the standard selection area.
4. Use the Up or Down navigation buttons to move the highlight focus to the desired standard.
5. Tap the Select button. An arrow () appears next to the selected standard and the screen
returns to the measure screen.
Manually Selecting Standard Numerically
The Numeric Standard Selection feature allows you to quickly select a different standard by
entering a numeric value. This is useful if there are many standards available in the project.
Standards are listed numerically from top to bottom.
To select a standard numerically:
1. From the Measure screen, use the Up or Down navigation buttons to move the highlight focus
to the Standard icon
.
2. Tap the Select or Right navigation button to access the standard selection area.
3. Tap the Right navigation button and highlight the Numeric Select icon
in the Progress
Column.
4. Tap the Select button to access the Numeric Index option.
5. Use the Up or Down navigation buttons to page through the available standards by number.
selected
Selecting No Standard causes no
standards to be used during
sample measurements. The
Manual Select standard option
must be activated in Configuration
to perform this function.
To Next Page
Loading...
Need help?
General
