CI6X SERIES SPECTROPHOTOMETER
46
4. Tap the Select button to access the option.
5. Use the Up or Down navigation buttons to page through the tolerance types. NOTE: For a
555 Shade Sort selection, refer to Editing 555 Shade Sort Values section that follows.
6. Tap the Select button to set the tolerance type.
NOTE: Color spaces and illum/obs combinations that appear here are the same that were
selected for the Allowed Color Space and Allowed Illum/Obs combinations options.
7. Use the navigation control to highlight illum/obs, SPIN/SPEX, or +/-tolerance value.
NOTE: Make sure the symmetric icon
is displayed if +/- tolerance attribute values are
going to be set as the same value. Highlighting the icon and tapping the Select button will
toggle between the two options.
8. Tap the Select button to access the option and use the Up or Down navigation buttons to
select option/value.
9. Tap the Select button to set the tolerance option/value.
10. Continue until all attributes for the first tolerance are set.
11. Tap the Right navigation button and highlight the checkmark icon
in the Progress Column.
12. Tap the Select button to save the edits for the first tolerance set.
NOTE: If additional tolerance sets (up to six) are required for the selected standard, highlight the
right arrow icon
is the Progress bar and tap the Select button. Edit the next tolerance set as
explained above.
Editing 555 Shade Sort Values
NOTE: The 555 Shade Sort option must be enabled in the Configuration for this option to appear.
The shade sort size is based on the dimensions placed on the color space attributes. The value
represents a three-dimensional box in space. These boxes are layered nine deep on each axis and
at the center is the 555 reference box. This box represents the reference color. The value in the
fields determines the reference box size. A smaller value is entered for a tighter tolerance. Values
range from .01 to 9.99.
To Next Page
Loading...
Need help?
General
