X-Rite DigiMatch PPG - Deleting All Measurement Jobs

PPG DIGIMATCH SPECTROPHOTOMETER
22
Delete Jobs
Single Job
1. To delete a saved job, tap the desired job in list. You will need to swipe the screen up or down if the job you
want to delete is not showing up in the list. A checkmark next to the job indicates the job is saved. Jobs that
are not checked indicates jobs that have not been measured.
2. Tap the icon and then tap Yes to confirm that you want to delete the job.
All Jobs
3. To delete all jobs, swipe the screen up to advance to the end of the list.
4. Tap the icon at the bottom of the screen and then tap Yes to confirm that you want to delete all the
jobs.