Installation
6 975-0171-01-01
Planning
AC, DC, and Network Components
For a successful installation, you need to plan for AC, DC, and network
components of the power system. The AC and DC components are described in
this section and illustrated in Figure 2 on page 7.
AC components include:
•AC Input
•AC Loads
• AC Disconnect and Over-Current Protection Device
• Distribution Panels
•AC Wiring
• AC Output Neutral Bonding
DC components include:
• Batteries
• DC Disconnects and Over-Current Devices
• DC Cabling
• DC Grounding
Network considerations include:
• Cables, connectors, network connectors, and terminators for the System
Control Panel and Automatic Generator Start, if installing.
Detailed information on planning and installing your network is available in
the Xanbus System Installation Guide. Refer to the system guide to determine
the type of network layout to install, as well as guidelines for installing the
network. This guide is available for download at www.xantrex.com
To Next Page
Loading...
