Operation
2–2 975-0170-01-01
Operating the RS3000 with the System Control Panel
The System Control Panel (SCP) provides operating, configuration, and
monitoring capability for your Xanbus system.
The System Control Panel:
• Monitors activity throughout your onboard power system.
• Displays the latest information about your inverter/charger, battery
charge level, battery charge output, and generator start and stop
activity.
• Displays the settings for each Xanbus-enabled device in the system.
• Enables you to adjust the settings for each Xanbus-enabled device in
the system.
• Preserves all of its settings if system power is interrupted. After
power is restored, you don’t have to reconfigure the SCP or any of the
Xanbus-enabled devices connected to it.
This section provides information on operating the RS3000 with the
System Control Panel. Please refer to the System Control Panel Owner’s
Guide for complete information on using the System Control Panel.
Important:
Any RS3000 setting changed from the System Control Panel will
be saved in the SCP if the unit is shut down by selecting Power Save mode, Safe
mode or Hibernate mode. See “Operating in Invert Mode” on page 2–6 for more
information about the different types of modes.
To Next Page
Loading...
Need help?
General