Wiring Requirements
WARNING
ELECTRICAL SHOCK AND FIRE HAZARD
Make sure that wiring is in good condition and that wire is not
undersized. Do not operate the solar charge controller with damaged
or substandard wiring.
Failure to follow these instructions can result in death,
serious injury, or equipment damage
WARNING
ELECTRICAL SHOCK HAZARD
Use a torque screwdriver to tighten the screw terminals on the charge
controller to 10.6 lb-in (1.2 N-m) torque to ensure a proper
connection.
Failure to follow these instructions can result in death,
serious injury, or equipment damage.
16 975-1012-01-01 Rev B
Oct 2019
To Next Page
Loading...
