Basic Installation Steps
WARNING
HAZARD OF ELECTRIC SHOCK AND FIRE
n User shall install a fuse that is 1.25 to 2 times the rated current
of the controller on the positive battery side with a distance
from the battery not greater than 150mm.
n Ensure that the "+" and "–" poles on both the battery and PV
are connected properly.
n Intended for indoor dry locations only.
n Do not charge a frozen battery.
n Minimum charge ambient for Li-ion batteries is 0°C(32°F).
Failure to follow these instructions can result in death,
serious injury, or equipment damage.
CAUTION
EQUIPMENT DAMAGE
Do not integrate this charge controller with a residential electrical
system.
Failure to follow these instructions can result in injury or
equipment damage.
1.
Prepare the tools for wall mounting and wiring installation.
•#2 Phillips screwdriver
•keyhole saw
•pencil
•power drill with bit set (see NOTE)
•other tools such as wire stripper, cutter, crimper, wrench
975-1012-01-01 Rev B
Oct 2019
19
To Next Page
Loading...
