Remote Operation
SCPI Commands for Digital Interfaces
Release 3.0 137
Operation
Users can select and start a sequence, and while the sequence is running, pause or
end it. Users can press and hold the TRIGGER button to skip over steps that have a
set duration.
Commands are also available to let users run, pause, resume, and restart an
autosequence. A pause, or wait for trigger, causes the power supply to hold the
output at the programmed level until the appropriate signal to continue is received.
Editing
Users can delete single steps or entire sequences. If a step is deleted, the subsequent
steps will shift up. If a new step is inserted, the subsequent steps will shift down.
Remote programming of auto sequences has the same functionality as using the front
panel.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
