XCell
TM
ATF System with C410:V3 Controller
Indicates Controller PLC is ON and in RUN mode
Indicates Diaphragm Pump is in RUN mode
Indicates Controller OFF/ON Status
Indicates Flow Direction Solenoid is OFF/ON
Press to START Diaphragm Pump
Press to STOP Diaphragm Pump
Press to Hide / Reveal the P2 Trending Screen
All Primary Screen Buttons are displayed to navigate to those screens.
Alarms, Trending, Batch Info, Set Up, Administration
When starting the pump, the following dialog box will appear:
Yes setting is preferred when stopping the Diaphragm Pump and restarting with the same
flow rate or process settings (i.e. same PRV and PV values as when the Diaphragm Pump last
ran).
Default setting is preferred when starting the Diaphragm Pump with new flow rate settings
or new process setup (e.g. different bioreactor configuration & parameters). This minimizes
the number of cycles taken by the controller to reach the desired flow rate. At any selected
flow rate, default simply resets the control parameters to factory preset values.
Cancel will return to the main screen without any action taken.
Stopping the pump, the following dialog box will appear:
To Next Page
Loading...