Need help?Do you have a question about the XCell ATF Series and is the answer not in the manual?
General| Brand | XCell |
|---|---|
| Model | ATF Series |
| Category | Laboratory Equipment |
| Language | English |
Explains the alternating flow generated by the diaphragm pump.
Outlines the functions and goals of the C410:V3 controller.
Lists compatible pump housing and controller models and their features.
Illustrates how the controller, pump, and bioreactor connect.
Describes the E-Box and P-Box components and their interconnections.
Details the components included in the Filtration Assembly.
Outlines the Operator Interface Terminal (OIT) features and primary/secondary screens.
Provides general rules for diaphragm motion and controller logic.
Provides a startup guide for an XCell™ ATF System connected to a bioreactor.
Provides examples of process control settings for different scenarios.
Details steps to disconnect the filtration assembly from the bioreactor.
Provides steps for removing the Hollow Fiber Module from the assembly.
Guides on how to properly insert a new HFM.
Directs users to contact Repligen for screen module replacement.
Explains diaphragm replacement procedures for different ATF systems.
Lists pre-autoclaving checks and procedures for the assembly.
Outlines typical autoclave cycle parameters and procedures for sterilization.
Covers sterilization of the filtrate/harvest line.
Details the procedure for making a hard connection to a bioreactor.
Recommends diaphragm replacement for each new run.
Explains when to replace the pump air inlet filter.
Advises on periodic replacement of O-rings and gaskets.
Outlines bi-annual and four-year maintenance tasks for the controller.
To Next Page