September 2001 88XX Series Folder Operator Manual 20
Face Submenu
Use this menu to obtain the folded prints Face Up or Face Down in the
print tray.
1. Go to the “Face” submenu.
in the Numeric Control Panel in the Alphanumeric Control Panel
u OPERATOR
U3 FACE
2. The default option is shown :
in the Numeric Control Panel in the Alphanumeric Control Panel
30 1
FACE UP
Lower right dot flashing
3. Use the scroll key to select the desired option and press Enter to
select it.
Select “FACE UP” [U3.01] to obtain all the folded prints oriented
face up.
Select “FACE DOWN” [U3.02] to obtain all the folded prints
oriented face down.
Selecting “DON’T CARE” [U3.03] tells the folder to accept every
print with all possible title block locations and orientations
LEF/SEF. With this selection the output orientation could be either
Face Up or Face Down.
4. Select EXIT [ u3.00 ] to rise one level.
5. Turn off the folder and then switch it on to activate the
modification.
Face
u 3
Exit
u 3.00
u 3.01
Face
down
u 3.02
Don't
care
u 3.03
To Next Page
Loading...
Need help?
General
