Xerox 8830 - Making Copies (continued); Document Scaling: Reduction and Enlargement

September 2001 88XX Series Folder Operator Manual 22
Punching Submenu
Use this submenu to activate the punching system if it is available.
1. Go to the “Punching” submenu.
in the Numeric Control Panel in the Alphanumeric Control Panel
u OPERATOR
U5 PUNCHING
2. The default option is shown.
in the Numeric Control Panel in the Alphanumeric Control Panel
u
5 02
PUNCHING OFF
Lower right dot flashing
3. Use the scroll key to select the desired option and press “Enter” to
select it.
4. Select EXIT [ u5.00 ] to rise one level.
If an option is not available, code E-14 “NOT AVAILABLE
SELECTION,” will appear.
WARNING!
The punching device is available only with programs:
185 with margin 25mm
190 with margin 20mm
7.5 with margin 1”
WARNING!
The activation/deactivation of the punching by PC works only if
on the folder is selected the option “Punching On”.
If the selection on the PC do not produce any effect on the
punching device, set ”Punching on” on the folder control panel.
Punching
u 5
Exit
u 5.00
Punching
on
u 5.01
Punching
off
u 5.02