Xerox
®
DocuMate
®
3220
User’s Guide
179
Driver Configuration
Use the Driver configuration section to configure the add-on modules, select interface options, and view
the scanner hardware properties. When the
Advanced configuration mode is selected, a scanner panel
option will be available for you to change any hardware settings that may be available for your
scanner.
Disabled Options in this Section
Some options in the interface may be grayed out and cannot be selected. Grayed out options are either
not appropriate for the current scanner, the software needed to enable the feature is not installed,
or
the feature is dependent on another setting in the scanner's interface. Hover the mouse cursor over a
grayed out feature to see information about why the feature is unavailable.
Module Configuration
When image processing modules are installed they will appear in the list on the Configure tab. Use this
tab to enable the modules you want to use when scanning.
There are some features in the scanner interface that are disabled until a module is installed that
contains those options. When the module is installed, the features will enable in the scanner interface
for you to use them.
Reordering the Modules
Select a module in the list and click the up or down arrow to change the order of the module in the list.
Changing the order of the modules changes the order in which the image processing options are used.
For example, if there are two modules installed and both modules include an automatic image rotation
option, the first module's rotate option is used and the rotate setting in the second module is ignored
so that the image is not rotated twice.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
