Xerox
®
DocuMate
®
3640
User’s Guide
170
When this option is available, it is an advanced user and application option and should not be adjusted
if you are not familiar with the technology. However, if you are certain that you are using an
application that can receive a compressed image, and you want to be able to change the image
compression type, you will need to enable user adjustable compression in the scanning interface.
Please refer to the Driver Settings section for instructions.
Please note that if you adjust this setting, and the application cannot actually accept the option you
change, the scanning interface and the application may crash. It is highly recommended that you
leave the default options and let the application set any image compression.
From the Windows Control Panel
1. Click on the Driver settings tab.
2. Select Enable user compression and Remember compression.
Note that if these two options are grayed out and you cannot select them, then these options are
not available for your scanner.
3. Click on OK.
4. Open the scanner interface.
5. Change to the Advanced source configuration mode.
6. In the Document settings section click on the Advanced tab.
7. If your scanner and application supports compressed file transfers, the Compression option will
now be available.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
