Installing the Feature Enhance Kit 89
Aligning the notch in the ROM card with the
tab in the R2 slot, insert the card straight into
the slot. Next, press the ROM card down
firmly into the slot.
Note
• Make sure the ROM card is inserted securely as far as it
can go.
• When the ROM card is installed correctly, the retaining
clips on both ends stand up.
6. Reinsert the control board back into the
printer. Holding its handle, slide the control
board back into the printer.
Press the control board in as far as it will go.
7. Tighten the two screws to secure the control
board in place.
8. Connect the power cord to the printer.
Press the <|> side of the printer's power
switch to turn on the power.
The installation is now complete.
Next, continue from step 9 enable the Feature
Enhance Kit feature from the control panel.
Important
• Once you install the Feature Enhance Kit and enable it
with the control panel, that Feature Enhance Kit is not
usable on any other printer.
9. Press the <Menu> button on the control
panel to display the menu screen.
10. Press the < > button until [Admin Menu] is
displayed.
11. Press the < > or <OK> button to select.
[Network/Port] is displayed.
12. Press the < > button until [System Settings]
is displayed.
13. Press the < > or <OK> button to select.
[Alert Tone] is displayed.
Insert securely as
far as it can go.
Menu
LanguageEmulation
Menu
Admin Menu
Admin Menu
Network/Port
Admin Menu
System Settings
System Settings
Alert Tone
To Next Page
Loading...
Need help?
General