94 A Appendix
Installing the Korea Font
ROM
This section describes how to install the Korea
Font ROM on the printer.
1. Switch the power off by pressing the < >
side of the power switch.
2. Unplug the power cord from the power outlet
and the printer.
3. Loosen the two screws on the back right side
of the printer.
4. Pull out the handle on the control board and
then carefully pull the control board out of the
printer. Place the control board on a table top
or some other flat surface.
Important
• When pulling out the control board, hold it with both
hands so you do not drop it.
5. Insert the Korea Font ROM card into slot R2
as shown in the illustration to the right.
Aligning the notch in the ROM card with the
tab in the R2 slot, insert the card straight into
the slot. Next, press the ROM card down
firmly into the slot.
Note
• Make sure the ROM card is inserted securely as far as it
can go.
• When the ROM card is installed correctly, the retaining
clips on both ends stand up.
Korea Font ROM
Insert securely as
far as it can go.
To Next Page
Loading...
Need help?
General