Paper and Other Media
Xerox Phaser 4622
User Guide
60
Press the up/down arrows to highlight the option required and press OK.
4. Press the up/down arrows to highlight the setting required and press OK to save the selection.
5. Continue customizing the Tray Management settings as required, then press Stop to return to
ready mode.
Auto Tray Switching This option enables the machine
to switch between trays if both
trays have the same size of
paper and a tray becomes
empty.
If Auto Tray Switching and
Tray Sequencing are enabled,
the Sequence settings
allow
the user or administrator to
specify the next tray to use if
the current tray runs out of
media
. For setup instructions,
refer to the System
Administrator Guide.
•On
•Off
Tray 1 (Bypass) Use this option to set the Tray
Mode and Tray Prompt options.
Tray Mode sets the tray to:
• Static: The paper size and
type is specified by the user
when loading the tray.
• Permanent: The paper size
and type is permanently set
and cannot be changed by
the user during paper
loading. The paper type and
size requested must be
loaded.
• Dynamic: The paper size
and type are dictated by the
print job being sent. The
tray is selected using the
printer driver.
• Bypass: Allows a print job to
start or continue by
accepting any paper loaded
into Tray 1 (Bypass), and
print on that paper,
regardless of what the print
job specifies.
Tray Prompt enables a prompt
to change the tray settings
when a tray is opened and
closed.
•Tray Mode
•Tray Prompt
Tray 2 •Tray Mode
•Tray Prompt
Tray 3 •Tray Mode
•Tray Prompt
Tray 4 •Tray Mode
•Tray Prompt
Tray 5 •Tray Mode
•Tray Prompt
Tray 6 •Tray Mode
•Tray Prompt
Option Description Settings
To Next Page
Loading...
Need help?
General
Weight and Dimensions
