Setups
Xerox Phaser 4622
User Guide
81
7. Continue customizing the Network Settings options as required, then press Stop to return to
ready mode.
PostScript Setup
1. Press the Menu button on the control panel.
2. Press the up/down arrows to highlight Tools and press OK.
Note If a password is required, refer to Accessing Tools on page 78 for instructions.
3. Press the up/down arrows to highlight Setup and press OK.
4. Press the up/down arrows to highlight PostScript Setup and press OK.
The following PostScript Setup options and settings are available:
5. Press the up/down arrows to highlight the option required and press OK.
6. Press the up/down arrows to highlight the setting required and press OK to save the selection.
7. Continue customizing the PostScript Setup options as required, then press Stop to return to ready
mode.
PCL Setup
1. Press the Menu button on the control panel.
2. Press the up/down arrows to highlight Tools and press OK.
Note If a password is required, refer to Accessing Tools on page 78 for instructions.
3. Press the up/down arrows to highlight Setup and press OK.
4. Press the up/down arrows to highlight PCL Setup and press OK.
The following PCL Setup options and settings are available:
Option Description
PostScript Error Info Enables the machine to print a PostScript Error
page if PostScript problems occur during printing.
Edge to Edge Printing Used to print to the edge of the output
documents.
Option Description
Font Number Sets the default PCL font.
Pitch Sets the default pitch (size) for PCL fonts.
Symbol Set Sets the default symbol set for PCL fonts.
Orientation Sets the default orientation.
Form Length Sets the default number of lines per page.