Xerox Phaser 7100 System Administrator Guide

Network Configuration
Phaser 7100 Color Printer
System Administrator Guide
30
Raw TCP/IP Printing
Raw TCP/IP is a printing method used to open a TCP socket-level connection over Port 9100, to stream
a print-ready file to the printer input buffer. The connection is then closed either after sensing an End
Of Job character in the PDL or after expiration of a preset timeout value. Port 9100 does not require an
LPR request from the computer or the use of an LPD running on the printer. Port 9100 is selected in
Windows as the Standard TCP/IP port.
Enabling Port 9100
Note: TCP/IP must be enabled before Port 9100 is enabled.
1. In CentreWare Internet Services, click Connectivity > Port Settings.
2. Select Enabled next to Port 9100.
Configuring Port 9100
1. In CentreWare Internet Services, click Properties > Connectivity > Protocols > Port 9100.
2. If required, select Enabled next to TCP-MSS Mode.
Note: TCP-MSS settings are common to LPD and Port 9100.
3. If TCP-MSS mode is enabled, under IPv4, type the IP addresses for Subnet 1, 2, and 3.
4. Ensure that the TCP Port Number is set to 9100.
5. Set the End of Job Timeout to the desired number of seconds between 2 and 65535 before
processing a job with an End of Job character. The default time is 60 seconds.
6. Click Apply.

Xerox Phaser 7100 Specifications

General

Maximum Print Resolution	1200 x 1200 dpi
Monthly Duty Cycle	Up to 52, 000 pages
Processor	667 MHz
Memory (Standard)	256 MB
Paper Input Capacity (Maximum)	2, 050 sheets
Paper Output Capacity	250 sheets
Duplex Printing	Automatic
Type	Color Laser Printer
Operating System Compatibility	Windows, Mac OS, Linux
Connectivity	USB 2.0, Ethernet
Supported Media Sizes	A4, A5, B5, Letter, Legal
First Page Out (Black)	9 seconds
First Page Out (Color)	9 seconds
Print Languages	PCL 6, PostScript 3
Network Connectivity	Ethernet
Print Speed	Up to 30 ppm