Security
Phaser 7100 Color Printer
System Administrator Guide
51
IPsec
Internet Protocol Security (IPsec) is a group of protocols used to secure Internet Protocol
communications by authenticating and encrypting each IP data packet. IPsec allows you to control IP
communication by creating protocol groups, policies, and actions for the following:
Configuring IPSec
Note: Secure HTTP (SSL) must be enabled with an installed digital certificate before you can
enable IPsec.
1. In CentreWare Internet Services, click Properties > Security > IPSec.
2. Select Enabled next to Protocol.
3. Select IKE Authentication Method, Preshared Key, or Digital Signature.
4. If you select Preshared Key, type the Shared Key, then retype the key to verify.
5. Type the IKE SA Life Time (5–28800 minutes).
6. Type the IPSec SA Life Time (300–172800 minutes).
7. Select the DH Group type.
8. Select G1 or G2 from the DH Group drop-down menu.
9. Enable PFS as needed.
10. Type the Specific Destination IPv4 Address.
11. Type the Specific Destination IPv6 Address.
12. To restrict the printer from communicating with devices that are not using IPSec, select Disabled
next to Communicate with Non-IP Sec Device.
13. Click Apply to accept the changes or Undo to retain the previous settings.
• DHCP v4/v6 (TCP and UDP)
• DNS (TCP and UDP)
•FTP (TCP)
• HTTP (Scan Out, TCP port 80)
• HTTPS (Scan Out, TCP port 443)
• HTTPS (Web Server, TCP port 443)
•ICMP v4/v6
• IPP (TCP port 631)
• LPR Print (TCP port 515)
• Port 9100 Print (TCP port 9100)
• SMTP (TCP/UDP port 25)
• SNMP (TCP/UDP port 161)
• SNMP Traps (TCP/UDP port 162)
• WS-Discovery (UDP port 3702)
• Up to 10 additional services
To Next Page
Loading...
Need help?
General
