Printing on Specialty Media
Phaser® 7760 Color Laser Printer
3-33
Printing on Specialty Media
This section includes:
■ Printing Transparencies on page 3-33
■ Printing Envelopes on page 3-36
■ Printing Labels on page 3-38
■ Printing Glossy Paper on page 3-40
■ Printing Custom Size Paper on page 3-45
Printing Transparencies
Transparencies can be printed from Tray 1 (MPT) and Tray 2. They should be printed on one
side only.
For best results, use only Xerox Digital Color Clear Transparency Film. For more information,
see the Recommended Media List at www.xerox.com/paper
.
To order paper, transparencies, or other specialty media, contact your local reseller or go to
www.xerox.com/office/supplies
.
Caution: Damage caused by using unsupported paper, transparencies, and other specialty
media is not covered by the Xerox warranty, service agreement, or Total Satisfaction
Guarantee. The Total Satisfaction Guarantee is available in the United States and Canada.
Coverage may vary outside these areas; please contact your local representative for details.
Guidelines
■ Remove all paper before loading transparencies in the tray.
■ Do not load more than 50 transparencies in Tray 1 (MPT). Do not load more than
200 transparencies in Tray 2. Overloading the tray may cause the printer to jam.
■ Handle transparencies by the edges using both hands to avoid fingerprints and creases,
which can cause poor print quality.
■ After loading the transparencies in the tray, use the control panel to change the paper
type to
Xerox Transparency.
Downloaded From ManualsPrinter.com Manuals
To Next Page
Loading...
Need help?
General