a. Place the bracket on the locating pins on the upper frame and in the grooves on the bottom of the tray.
b. To lock the postcard bracket in place, tighten the thumbscrew.
5. Load the postcard stock SEF (short-edge feed) and against the right side of the tray.
6. Adjust the paper guides against the paper stock.
7. Close the paper tray. At the control panel touch screen, confirm the new settings.
8. Run your print job.
9. Upon completion of your print job, remove the postcard stock and the postcard bracket from the tray.
Xerox
®
PrimeLink
®
B9100/B9110/B9125/B9136 Copier/Printer User Guide 313
Oversized High Capacity Feeder
To Next Page
Loading...
Need help?
General