3. Move the width guides to the edges of the tray.
Note
• To prevent jams, ensure that the leading edge of the envelopes are flat or have only a slight
upward curl, less than 5 mm (.19 in.), before loading into the tray. If the edge is curled or swollen,
fold it over to decurl. The length of the curl must be within 8–10 mm (.31–.39 in.). Downward
curl at the leading edge of envelopes is not acceptable and can cause a jam or misfeed.
• Load envelopes up to 16.5 mm (.65 in.) in height. This is approximately 10–20 envelopes,
depending on brand, size, and texture.
• If you do not load envelopes in the Bypass Tray right after you have removed the envelopes
fromthe packaging,the envelopescanbulge. Toavoid jams, flatten the envelopes beforeloading
them into the tray.
4. To load the envelopes, select an option:
• For Number 10 envelopes, load the envelopes with the short edge going into the printer, flaps
down, and flaps to the right.
6-17Xerox
®
VersaaLink
®
B600/B610 Printer
User Guide
Paper and Media
To Next Page
Loading...
Need help?
General